ACU-RITE 200S READOUTS Manuel d'utilisateur télécharger pdf (Page 43)

200S 29

I - 3 Milling Specific Operations

8 Press the DATUM soft key.

8 Press the DOWN arrow key to select the item you need.

8 Press the PROBE soft key.

Probe the 1st edge X

8 Move the edge finder toward workpiece edge 1 until the LEDs in the

edge finder light up.

Probe the 2nd edge in X

8 Move the edge finder toward workpiece edge 2 until the LEDs in the

edge finder light up. The distance between the edges is displayed

on the message box.

8 Retract the edge finder from the workpiece.

Enter the value for X

8 Enter coordinate (X = 0.0), and transfer coordinate as datum for the

centerline.

8 Press the ENTER hard key.

Example: Probe the center of a hole with an edge finder, and set

the datum 2.00” from the circle’s center

X coordinate of the circle center: X = 2.00

Y coordinate of the circle center: Y = 0.00

8 Press the DATUM soft key.

8 Press the DOWN arrow key.

8 Press the PROBE soft key.

8 Press the CIRCLE CENTER soft key.

8 Move the edge finder toward the first point 1 on the circumference

until the LEDs in the edge finder light up.

8 Probe two additional points on the circumference in the same

manner. Further instructions appear on the screen. See Instruction

Box for the measured diameter.

Enter center point X X = 2.00”

8 Enter the first coordinate (X = 2.00”).

8 Press the DOWN arrow hard key.

Enter center point Y Y = 0.00

8 Accept default entry Y = 0.00.

8 Press the ENTER.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 97 98

Pas de commentaire

ACU-RITE 200S READOUTS Manuel d'utilisateur Page 43