ACU-RITE 200S READOUTS Manuel d'utilisateur télécharger pdf (Page 38)

24 I

I - 3 Milling Specific Operations

Entering tool data

8 Choose TOOL soft key.

8 Cursor to the desired tool and press ENTER. The Tool Description

form will appear.

8 Enter the tool diameter.

8 Enter the tool length or press TEACH LENGTH.

8 Enter the tool units (inch/mm).

8 Enter the tool type.

8 Spindle data is not required unless the Spindle Speed Control has

been installed. If installed, then refer to the CSS I/O User’s Manual.

8 Press C to return to the tool table. Press C to exit.

Tool Table Usage

Example: Entering the tool length and diameter into the tool table.

Tool diameter 2.00

Tool length: 20.000

Tool unit: mm

Tool type: flat end mill

It is also possible to have 200S determine the length of an

offset. See - ALTERNATIVE METHOD -.

Spindle Speed Control information is only required when

CSS I/O box is installed. Refer to the CSS I/O User Manual

if this has been installed.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 97 98

Pas de commentaire

ACU-RITE 200S READOUTS Manuel d'utilisateur Page 38