Acu-rite SENC 150 Manuel d'utilisateur télécharger pdf (Page 12)

Encoder Installation Procedure SENC 150

Thesestepsapplytoallencodermountingconditions,ifasparis

beingused,goto“SparInstallationProcedure”onpage11.

• ACU-RITE

bracket kit instructions supercede this section.

• Adjustdrilldepthsandfastenerlengthsasrequired.

• Wheninstructedonpage10:Adjustthelevelingsetscrewsas

follows:

1.Insert,butdonottighten8-32(M4)readingheadscrews.

2.Placea.001”-.003”shimbetweenthelevelingsetscrews

and mounting surface.

3.Adjusteachsetscrewuntilaslightdragisfeltontheshim.

4.Evenlytightenthe8-32(M4)readingheadmountingscrews.

• ContactyourAuthorizedDistributorshouldyourequire

additional assistance.

• Alignthecentermarksonthereadingheadandscaleassembly

by sliding the reading head and brackets along the case.

• Locatethescalecasesoundersideofendcapsareushwith

theaxispartingline.

• Markoneendmountingholelocation.

• Movethemachineaxistoitscenteroftravel.

• Marktheaxisforquickreturntocenter.

• Conguretheencodercableexitdirection(seepage3).

Scale case

Reading head assembly

Alignment

brackets (2)

Aligntopofscalecaseto

within.015”of-A-

-A-=Axistravel

Cable assembly

End cap

Scale case

Axispartingline

End mounting hole (typical)

Center marks

Center mounting axis

Markcenteroftravel

ACU-RITE

516291-21_Ve00_SENC_150.indd 12 10/22/2009 10:00:43 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Acu-rite SENC 150 Manuel d'utilisateur Page 12